Canon imagePROGRAF iPF9400S - Manual (Page 558)

1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6
Press ▲ or ▼ to select Manual, and then press the OK button.
7
When Perform the detection of paper leading edge? is displayed, select Do not perform.
Note
• If you set the detection of paper leading edge to Do not perform, a margin of about 10 cm is created at the paper
leading edge when printing starts.
• When the detection of paper leading edge is set to Do not perform, printing will start at the position at which the roll
was set for the first printing after replacing a roll. Thus, the margin of the paper leading edge will enlarge.
(See "Loading Rolls in the Printer.")
→P.541
8
Press the Feed button.
9
Press ▲ or ▼ to align the paper leading edge with the
(a) position.
Specifying the Cutting Method for Rolls iPF9400S
User's Guide
Handling and Use of Paper
Handling rolls
558