Canon imagePROGRAF iPF9400S - Manual (Page 676)

Setting Item Description, Instructions
Paper Details (The type of paper
is displayed here.)
(*1) Trim Edge First Selects whether or not to automatically cut the leading edge of the roll
paper when roll paper is loaded.
(See "Cutting the Leading Edge of Roll Paper Automatically.")
→P.560
CutDustReduct. If you choose On, a line will be printed at the cut position when paper
cutting is selected. This option reduces the amount of debris given off
after cutting. It also helps prevent adhesive from sticking to the cutter
and keeps the cutter sharp if you use adhesive paper. (See "Reducing
Dust from Cutting Rolls.")
→P.562
VacuumStrngth Specify the level of suction that holds paper against the Platen. (See
"Adjusting the Vacuum Strength.")
→P.819
Roll Tension Adjust the slack of the roll paper loaded in the printer.
If there is slack in thin roll paper and the paper is becoming scratched,
or wrinkles or creases are occurring, set this to High to make it harder
for slack to occur, and reduce the amount of scratches, etc.
If you change the Roll Tension setting, We recommend that you per-
form Adj. Quality. (See "Automatic Banding Adjustment.")
→P.814
Scan Wait Time Specify the time to wait for the ink to dry between each scan (after the
printhead finishes moving in one direction), in consideration of how
quickly the ink dries. Also specify the applicable area for the ink drying
time. Select Entire area to apply the ink drying time after each scan un-
til the document is fully printed. Select Leading edge to apply the ink
drying time after each scan only in the area 110–160 mm from the lead-
ing edge. (The applicable length varies depending on the Print Quality
setting.) Note that printing will take longer if you specify the Scan Wait
Time setting. In particular, when Leading edge is selected, colors may
be uneven in the boundary between the areas with and without a drying
time.
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper to ensure
better printing quality at the leading edge.
Note that if you choose 5mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may be
scratched, and ink may adhere to the leading edge. It may also cause
the Platen to become soiled.
NearEnd Sht Mrgn Specify a margin at the leading edge of sheets to ensure better printing
quality at the leading edge.
Note that if you choose 5mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may be
scratched, and ink may adhere to the leading edge.
"BordlessOver-
size" Select the amount of oversize extension of the original during border-
less printing.
Normally, we recommend that you set this to Standard.
If it is set to "Little", although it will reduce soiling on the back surface,
white patches may remain on the printed surface.
Width Detection Specify this option to print inside boundaries or in other cases when
specifying a particular starting position for printing.
Paper width and skew are not detected if you select Off. If paper is loa-
ded askew, paper jams or Platen soiling may occur.
Return Defaults Choose OK to restore Paper Details to the default values.
Paper Details Print the paper settings as specified in Paper Details.
Keep Paper Type Select On when printing on a particular type of paper regularly. (See
"Changing the Type of Paper.")
→P.545
Menu Settings iPF9400S
User's Guide
Control Panel
Printer Menu
676