End of paper feed, Rel lever is in wrong position, Rewinding error – Canon imagePROGRAF iPF9400S User Manual
Page 925: Rel lever is in wrong position rewinding error
Cause
Corrective Action
There are sheets left on the Ejec-
tion Guide.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
There is a foreign object by the
Output Tray, obstructing the Cut-
ter Unit.
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
You are not using the printer un-
der the recommended environ-
mental conditions for the paper.
Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions, see the Paper Reference Guide.
(See Paper Reference Guide.)
You are using paper that is not
compatible with automatic cut-
ting.
1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See Paper Reference Guide.)
2.
Lift the Release Lever and remove the paper.
In other cases, the Cutter Unit
may be damaged.
Contact your Canon dealer for assistance.
End of paper feed.
End of paper feed.
Cause
Corrective Action
Although an attempt was made to advance the paper manually, it reached the limit position
that can be advanced.
Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.
Canceling manual advancing.
Rel lever is in wrong position.
Rel lever is in wrong position.
Cause
Corrective Action
The Release Lever is up. Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Rewinding error.
Rewinding error.
Cause
Corrective Action
There is some foreign object near the Media Take-up Unit sensor and
the roll cannot be detected.
Remove the foreign object near the sensor.
The Media Take-up Unit sensor is soiled and the roll cannot be detec-
ted.
Wipe the sensor with a dry cloth to clean it.
The roll is out of range of detection by the Media Take-up Unit sensor.
Reload the roll.
Press the OK button to clear the error.
(See "Loading Rolls in the Printer.")
(See "Loading the Rewind Spool on the Media Take-up Unit.")
A paper jam has occurred and the roll cannot be rewound.
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
The Media Take-up Unit sensor is damaged.
Contact your Canon dealer for assistance.
*1: Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip Take-Up Err
to On. However, note that this error may cause paper jams and affect the printing quality.
iPF9400S
End of paper feed.
Error Message
Messages regarding paper
925