Canon imagePROGRAF iPF9400S - Manual (Page 879)

5
Close the Top Cover.
6
Tape down printer covers to secure them, in the reverse order of tape removal during installation.
7
If the Output Stacker is installed, reverse the installation procedure to remove the Output Stacker.
8
Remove the Stand by reversing the installation procedure, when it was attached to the printer.
9
Disassemble and repackage the Stand by following the installation procedure (with six people lifting the printer)
in reverse.
Important
• Do not use the procedure for rotated installation (installing by rotating the printer). This may damage the printer. For
details, see Setup Guide.
10
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shipping
box.
Updating the Firmware Updating the Firmware
Update the printer firmware to take advantage of new and improved printer functions.
Confirming the firmware version
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Printer Info, and then press the OK button.
4
Press ▲ or ▼ to select System Info, and then press the OK button.
The firmware version is displayed.
iPF9400S Updating the Firmware
User's Guide
Maintenance and Consumables
Other Maintenance
879