Agilent Technologies AGILENT U2761A - Manual (Page 83)

Features and Functions 2
U2761A User’s Guide 65
Phase Deviation
The phase deviation setting represents the peak variation in
phase of the modulated waveform from the carrier
waveform. The phase deviation setting can be set from
0 to 360
°. The default phase deviation setting is 180°.
Soft Front Panel Operation
On the Phase Deviation panel as shown in Figure 2- 20 ,
input the desired phase deviation value.
Remote Interface Operation
PM:DEViation <deviation in degrees>
Generate PM Using SCPI Commands
Example 1
-> *CLS ; *RST //To reset the U2761A to default
power -on state, this command
can be ignored if this operation
is not required.
-> PM:STAT ON //Enables PM.
-> FUNC SIN //Sets the carrier waveform to
Sine wave.
-> FREQ 1000 //Sets the carrier frequency to
1 kHz.
-> VOLT 5 VPP //Sets the output amplitude to
5 Vpp.
-> VOLT:OFFS 0 //Sets the output offset to 0.
-> PM:INT:FUNC SIN //Changes the modulating
waveform shape to Sine wave.
-> PM:INT:FREQ 500 //Changes the modulating
frequency to 500 Hz.
-> PM:DEV 180 //Changes the phase deviation to
180
°.
-> OUTP ON //Turns on output.