HP LaserJet 5200 Printer series - Manual (Page 147)

Control panel message Description Recommended action
<Date> <Time>
To change press
To skip, press STOP
The printer has an internal clock that tracks
the date and time. You are prompted to set
the correct date and time the first time you
turn on the printer. Press to change the date and time.
Press Stop to skip this step. You can set
the date and time later by using the
SYSTEM SETUP menu.
If the prompt appears each time you turn on
the printer, the clock is not working
correctly. Contact HP support.
Access Denied MENUS LOCKED The printer administrator has enabled the
control-panel security mechanism. You
cannot modify control-panel settings in this
circumstance. The message disappears
after a few seconds, and the printer returns
to Ready or BUSY state. Contact the printer administrator to change
settings.
ACTION NOT CURRENTLY AVAILABLE
ON TRAY X
alternates with
Tray size cannot be ANY SIZE/ANY
CUSTOM
You are trying to set duplex registration for
a tray that is configured for ANY SIZE or
ANY CUSTOM. Duplex registration is not
available when the tray size is set to either
of these settings. Change the size setting for the tray.
BAD DUPLEXER CONNECTION
alternates with
To continue turn off then on
The duplexer is not installed correctly. Turn the printer off and then on to continue.
Calibrating... The printer is calibrating. No action necessary.
Canceling... <JOB NAME> The printer is in the process of canceling a
job. The message appears while the job is
stopped, the paper path is flushed, and any
remaining incoming data on the active data
channel is received and discarded. No action necessary.
Checking paper path The engine is turning the rollers to check
for possible jams. No action necessary.
Checking printer The engine is performing an internal test. No action necessary.
CHOSEN PERSONALITY NOT
AVAILABLE
alternates with
To continue press
The printer encountered a request for a
personality that did not exist in the printer.
The job is cancelled and no pages are
printed. 1. Press to continue.
2. Try a different driver.
CLEANING DISK X% COMPLETE
alternates with
DO NOT POWER OFF
The memory disk is being cleaned. This
process might take up to an hour. During
this time, no jobs can be printed. Do not turn off the printer. Wait for the
process to complete.
The printer automatically restarts at the end
of the cleaning process.
Cleaning... The printer is processing the cleaning page. No action necessary.
Clearing event log This message appears while the event log
is cleared. The printer then returns to the
SERVICE menu. No action necessary.
ENWW Control-panel messages 133