HP LaserJet 5200 Printer series - Manual (Page 79)

Customizing tray 1 operation
The printer can be set to print from tray 1 if it is loaded, or to print only from tray 1 if the type of media
that is loaded is specifically requested. See
Paper Handling menu .
Setting Explanation
TRAY 1 TYPE=ANY
TRAY 1 SIZE=ANY
The printer usually pulls media from tray 1 first unless it is empty or closed. If
you do not keep media in tray 1 all the time, or if you use tray 1 only to manually
feed media, keep the default setting of TRAY 1 TYPE=ANY and TRAY 1
SIZE=ANY on the Paper Handling menu.
TRAY 1 TYPE= or TRAY 1 SIZE= a type
other than ANY The printer treats tray 1 like the other trays. Instead of looking for media in tray 1
first, the printer pulls media from the tray that matches type and size settings
that are selected in the software.
In the printer driver, you can select media from any tray (including tray 1) by
type, size, or source. To print by type and size of paper, see
Controlling print jobs .
You can also determine whether the printer shows a prompt to ask if it can pull media from tray 1 if it
cannot find the type and size that you requested in another tray. You can set the printer to always
prompt you before pulling from tray 1 or only prompt you if tray 1 is empty. Set the USE
REQUESTED TRAY setting on the System Setup submenu of the Configure Device menu.
Loading tray 2 (250-sheet tray)
Tray 2 supports only paper. For supported paper sizes, see Paper specifications .
To load tray 2
1. Pull the tray out of the printer and remove any paper.
ENWW Configuring trays 65