HP LaserJet 5200 Printer series - Manual (Page 226)

4. Connect the network cable to the EIO card.
5. Replace the right cover, turn on the printer, and then print a configuration page to verify that the
new EIO device is recognized. See
Using printer information pages .
NOTE When you print a configuration page, an HP Jetdirect configuration page that contains
network configuration and status information also prints.
Removing an HP Jetdirect print server card
1. Turn off the printer.
2. Disconnect the network cable from the EIO card.
3. Remove the two screws from the EIO card, and then remove the EIO card from the EIO slot.
4. Place the cover plate from the EIO slot onto the back of the printer. Insert and tighten the two
screws.
5. Turn on the printer.
212 Appendix E Working with memory and print server cards ENWW