HP LaserJet 5200 Printer series - Manual (Page 46)

Item Values Explanation
appears for each tray that is installed, and registration must
be set for each tray.
● X1 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray. For duplexing,
this side is the second side (back) of the paper.
● X2 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray, for the first
side (front) of a duplexed page. This item appears only
if the printer includes a built-in duplexer and DUPLEX
is ON. Set the X1 SHIFT first.
● Y SHIFT: Registration of the image on the paper from
top to bottom as the paper lies in the tray.
The default setting for SOURCE is TRAY 2. The default
setting for ADJUST TRAY 1 and ADJUST TRAY 2 is 0.
FUSER MODES List of available fuser modes Configures the fuser mode associated with each media type.
Change the fuser mode only if you are experiencing
problems printing on certain media types. After you select a
type of media, you can select a fuser mode that is available
for that type. The printer supports the following modes:
NORMAL: Used for most types of paper.
HIGH2: Used for paper that has a special or rough finish.
HIGH1: Used for rough paper.
LOW3: Used for transparencies.
LOW2: Used for lightweight media. Use this mode if you are
having problems with curled paper.
LOW1: Use this mode if you are experiencing wrinkled media.
The default fuser mode is NORMAL for all print media types
except transparencies (LOW3) and rough paper (HIGH1).
CAUTION Do not change the fuser mode for
transparencies. Failure to use the LOW3 setting
while printing transparencies can result in
permanent damage to the printer and fuser. Always
select Transparencies as the type in the printer
driver and set the tray type at the printer control
panel to TRANSPARENCY.
When selected, RESTORE MODES resets the
fuser mode for each media type back to its default
setting.
OPTIMIZE List of parameters Optimizes certain parameters for all jobs rather than (or in
addition to) optimizing by paper type.
RESOLUTION 300
600
Selects the resolution. All values print at the same speed.
300: Produces draft print quality and can be used for
compatibility with the HP LaserJet III family of printers.
32 Chapter 2 Control panel ENWW