HP LaserJet 5200 Printer series - Manual (Page 49)

Item Values Explanation
SIZE/TYPE PROMPT: Use this menu item to control
whether the tray configuration message and its prompts are
shown whenever a tray is opened and closed. These
prompts instruct you to set the type or size if the tray is
configured for a type or size other than the type or size that
is loaded in the tray.
SLEEP DELAY 1 MINUTE
15 MINUTES
30 MINUTES
45 MINUTES
60 MINUTES
90 MINUTES
2 HOURS
4 HOURS
Sets how long the printer remains idle before it enters Sleep
mode.
Sleep mode does the following:
● Minimizes the amount of power that the printer
consumes when it is idle.
● Reduces wear on electronic components in the printer
(turns off the display backlight, but the display is still
readable).
The printer automatically comes out of Sleep mode when
you send a print job, press a printer control-panel button,
open a tray, or open the top cover.
The default setting is 1 MINUTES.
WAKE TIME MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
SUNDAY
Sets a “wake-up” time for the printer to warm up and
calibrate each day. The default for each day is OFF. If you
set a wake time, HP recommends setting an extended sleep
delay time period, so that the printer will not return to sleep
mode soon after waking.
PERSONALITY AUTO
PDF
PS
PCL
Selects the default printer language (personality). The
possible values are determined by which valid languages
are installed in the printer.
Normally, you should not change the printer language. If you
change it to a specific printer language, the printer will not
switch automatically from one language to another unless
specific software commands are sent to the printer.
The default setting is AUTO.
CLEARABLE WARNINGS JOB
ON
Sets the amount of time that a clearable warning appears on
the printer control-panel display.
JOB: The clearable warning message appears until the end
of the job that generated the message.
ON: The clearable warning message appears until you press
.
The default setting is JOB.
AUTO CONTINUE OFF Determines how the printer reacts to errors. If the printer is
on a network, you probably want to turn AUTO CONTINUE
to ON.
ENWW Configure Device menu 35