HP Command View for Tape Libraries Software - Manual (Page 190)

5 CLI Command Reference
The following commands are available to all users. Click a command name in the table to jump
to the description of that command.
show drive serialnumber clear station
show drive status create host
show drive type download drive
show firmware available download interface
show firmware revisions download library
show host access download mgmt
show host info map host
show host name move media
show host sparselunmap reboot interface
show inet reboot library
show interface access reboot mgmt
show interface beacon replace interface
show interface hostport alpa remove host
show interface hostport connection restore interface defaults
show interface hostport mode restore system config
show interface hostport speed restore system defaults
show interface info save drive lttsupportticket
show interface name save interface lttsupportticket
show interface revision save library lttsupportticket
show interface status save ltt
show interface wwninfo save mgmt lttsupportticket
show library access save system config
show library info set drive hostport mode
show library interface set drive hostport speed
show library name set host name
show library productid set inet ftp
show library revision set inet telnet
show library sensors set interface beacon
show library serialnumber set interface clearwwnmismatch
show library status set interface hostport alpa
show library topology set interface hostport connection
show license set interface hostport mode
show media set interface hostport speed
show mgmt clock set mgmt clock
show mgmt info set mgmt ntp
show mgmt log detail set mgmt password
show mgmt log event set mgmt timezone
show mgmt revision set mgmt wwnstate
show mgmt status set mode
show mgmt timezone set net v6 dhcpv6
show mgmt wwnstate set net v6 ipaddress
show mode set net v6 ipversion
show net info set net v6 manual
show inet set net v6 stateless
show network dhcp set network config
show network ipaddress set network dhcp
show network snmpcommunity set network ipaddress
show partition set network snmpcommunity
show robotics status “set network snmptrap” (page 217)
190 CLI Command Reference