HP Onboard Administrator - Manual (Page 121)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 121
To set up your new SNMP alert's information, use the following fields.
Field Possible value Description
Alert Destination Protocol:
• udp—For IPv4 udp traps
• udp6 or udpv6 or udpipv6—For
ipv6 udp traps
• tcp—For IPv4 tcp traps ( only for
snmpv3)
• tcp6 or tcpv6 or tcpipv6—For
ipv6 tcp traps (only for snmpv3)
Destination:
• IPv4
address—###.###.###.###
where ### ranges from 0 to 255
• IPv6
address—####:####:####:###
#:####:####:####:#### where
#### ranges from 0 to FFFF. A
compressed version of the same
IPv6 address is also supported.
• DNS name—1 to 64 characters
including all alphanumeric
characters and the dash (-).
Port:
The port number is any valid and
available udp/tcp port number in the
range of [1;65535] (both inclusive). If
port is specified for an IPv6 address,
the IPv6 address must be enclosed in
[...]; for example,
[####:####::####]:162 to specify
port 162.
The management station IP address or
DNS name. Alert destination can be
specified in [protocol:]destination[:port]
format. Both protocol and port are
optional parameters.
Community String 0 to 20 characters including all
printable characters and the space A text string that acts as a password. It is
used to authenticate messages that are
sent between HP management server
and Onboard Administrator.
NOTE: While in FIPS mode ON/DEBUG, the SNMPv1 and SNMPv2 are disabled, and you can
create only SNMPv3 traps.
To configure the following fields, select the SNMPv3 check box:
• User—The SNMP user account to be used to send the trap/inform. Desired user-engineID must be
created before the alert destination can be added.
• Security—The security level used to send trap/inform. Security level options: No authorization or
encryption (noAuthNoPriv), Authorization but no encryption (authNoPriv), and Authorization and
Encryption (authPriv). The default is authNoPriv.
• Inform Message—If an inform message is specified, the agent expects to a receive notification from the
management application that the trap has been received. The agent retries to send traps if no inform
acknowledgment is received. Alerts with Inform Message enable must have a remote user, which is
available on a management solution.
To proceed with adding the SNMP alert, click Add Alert.