Configuration management screen – HP Onboard Administrator User Manual
Page 58
First Time Setup Wizard 58
o
If the configuration is not supported. The primary enclosure must be enabled for Two-Factor
Authentication and both the primary and linked enclosures must have the same credentials for the
linked enclosure to authenticate using Two-Factor Authentication. If the primary enclosure does not
have Two-Factor Authentication enabled, then you cannot select the linked enclosure with
Two-Factor Authentication enabled.
o
If you click the Sign Out link on a Two-Factor Authenticated enabled enclosure that is already
authenticated, this state appears. If you select this enclosure, then authentication is attempted when
you click Next.
•
Linked—Signed In with or without a card reader icon. This state indicates the linked enclosure is
authenticated. If the enclosure information has not been loaded already, then it is loaded when you
click Next.
If more than one enclosure is listed on the Enclosure Selection screen, select the enclosure you want to set up,
and then click Next.
For possible values and descriptions of each field, see "Enclosure Settings screen (on page
, on page
)."
Configuration Management screen
The Configuration Management screen enables you to set up the selected enclosures using a configuration
file saved from a previous setup. You can run scripts for multiple Onboard Administrators before leaving the
current screen.
To set up selected enclosures using a configuration file:
Select the enclosure to which you want to upload the configuration file. You can only upload the
configuration file to one enclosure, even if you selected All Enclosures on the Enclosure Selection screen. You
can select a local file, URL, or USB file:
•
Local file—You can browse for the configuration file or you can enter the path of the configuration file
into the textbox. The maximum number of characters in the file path is 256. Enter the configuration file
path, click Upload.
•
URL—If the configuration file is located on a web server, enter an HTTP path to the file. The maximum
number of characters in the file path is 256. After entering the URL, click Apply.