HP Onboard Administrator - Manual (Page 306)

Troubleshooting 306
95 Invalid domain.
97 Connecting to the blade's iLO failed.
98 Sending the RIBCL command to the requested blade failed.
99 Could not find the requested element in the RIBCL response.
100 Could not find the requested attribute in the RIBCL response.
101 Could not find the starting boundary in the RIBCL response.
102 Could not find the ending boundary in the RIBCL response.
103 Could not determine the IP address of the management processor for the requested blade.
104 Could not locate a Primary NTP server.
105 You must set at least one (1) trusted host before enabling trusted hosts.
107 Could not create the RIBCL request.
108 This error message should be taken from the soap errorText (varies).
118 The management processor auto-login feature is not supported.
119 The maximum number of EBIPA DNS servers has already been reached.
120 The starting IP address and Net Mask must be set before enabling EBIPA.
121 The LDAP group does not exist.
122 The LDAP group already exists.
123 The maximum number of LDAP groups has already been reached.
125 Error getting Insight Display information.
126 Error getting Insight Display status.
127 Error reading the certificate
128 Error setting the time zone.
129 Error installing the certificate.
130 Exceeded the maximum number of SSO certificates.
131 The X509 Certificate is not formatted correctly.
132 HP SIM station already in trusted list.
133 HP SIM station name not found.
134 HP SIM SSO API received a bad parameter.
135 The maximum number of HP SIM XE stations already configured.
136 The maximum number of EBIPA interconnects DNS servers has been reached.
137 The session could not be created.
138 The session could not be deleted.
139 Not a valid request while running in standby mode.
140 Not a valid request while transitioning to active mode.
141 Not a valid request while running in active mode.