Active onboard administrator virtual buttons tab – HP Onboard Administrator User Manual
Page 175
Configuring the HP BladeSystem c7000 enclosure and enclosure devices 175
Row
Description
Part Number
The part number to be used when ordering an additional or replacement Onboard
Administrator
Spare Part Number
The spare part number to be used when ordering an additional or replacement
Onboard Administrator
Serial Number
The unique serial number of the Onboard Administrator
Diagnostic information
Diagnostic information is gathered by polling a device microcontroller (resulting in a degraded status if a
failure has occurred) or is sent by the device microcontroller, without being polled to report a failure.
Row
Description
Device Identification
Data
This row displays information such as model name, part number, serial number, and
other information used to identify the device. This data is also referred to as FRU data.
A device identification data error appears if the data is not present or not readable by
the Onboard Administrator. Possible values are OK or Error.
Firmware Mismatch
The Onboard Administrator with the lowest firmware version displays this field when
two Onboard Administrators are present.
OA Battery
Status of the Onboard Administrator battery. Possible values are OK or Error.
Active Onboard Administrator Virtual Buttons tab
Click Reset to reset the Onboard Administrator. A confirmation screen appears, asking if you are sure that
you want to perform the action and that you will be signed out and disconnected from the Onboard
Administrator. Click OK to proceed, or click Cancel to exit without a change.
Click Toggle On/Off to change the Onboard Administrator module UID light. This button is useful in
identifying a particular Onboard Administrator when there are more than one.