HP Officejet 4314 All-in-One Printer User Manual
Page 40
To set up the HP All-in-One with a shared voice/fax line with answering machine
1.
Remove the white plug from the port labeled 2-EXT on the back of the HP All-in-
One.
2.
Unplug your answering machine from the telephone wall jack, and connect it to
the port labeled 2-EXT on the back of the HP All-in-One.
Note
If you do not connect your answering machine directly to the HP All-
in-One, fax tones from a sending fax machine might be recorded on your
answering machine, and you probably will not be able to receive faxes
with the HP All-in-One.
3.
Using the phone cord supplied in the box with the HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled 1-
LINE on the back of the HP All-in-One.
Note
If you do not use the supplied cord to connect from the telephone
wall jack to the HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office.
4.
(Optional) If your answering machine does not have a built-in phone, for
convenience you might want to connect a phone to the back of your answering
machine at the "OUT" port.
Note
If your answering machine does not let you connect an external
phone, you can purchase and use a parallel splitter (also known as a
coupler) to connect both the answering machine and telephone to the
HP All-in-One. You can use standard phone cords for these connections.
5.
Set the
Answer Mode
to
AnswerMachine
.
6.
Set your answering machine to answer after a low number of rings.
7.
Change the
Rings to Answer
setting on the HP All-in-One to the maximum
number of rings supported by your device. (The maximum number of rings varies
by country/region.)
8.
Run a fax test.
When the phone rings, your answering machine will answer after the number of rings
you have set, and then play your recorded greeting. The HP All-in-One monitors the
call during this time, "listening" for fax tones. If incoming fax tones are detected, the
HP All-in-One will emit fax reception tones and receive the fax; if there are no fax
tones, the HP All-in-One stops monitoring the line and your answering machine can
record a voice message.
Case J: Shared voice/fax line with computer dial-up modem and answering
machine
If you receive both voice calls and fax calls at the same phone number, and you also
have a computer dial-up modem and answering machine connected on this phone
line, set up the HP All-in-One as described in this section.
Since your computer dial-up modem shares the phone line with the HP All-in-One,
you will not be able to use both your modem and the HP All-in-One simultaneously.
User Guide
37
Finish
setup