HP Officejet 4314 All-in-One Printer User Manual
Page 79
To replace the print cartridges
1.
Make sure the HP All-in-One is on.
Caution
If the HP All-in-One is off when you open the print cartridge door
to access the print cartridges, the HP All-in-One will not release the
cartridges for changing. You might damage the HP All-in-One if the print
cartridges are not docked safely on the right side when you try to remove
them.
2.
Open the print cartridge door.
The print carriage should move to the far right side of the HP All-in-One. If the
print carriage does not move to the right side, close the door. Then, turn the
HP All-in-One off, and then on again.
3.
Wait until the print carriage is idle and silent, and then lightly press down on a
print cartridge to release it.
If you are replacing the tri-color print cartridge, remove the print cartridge from the
slot on the left.
If you are replacing the black print cartridge, remove the print cartridge from the
slot on the right.
1 Print cartridge slot for the tri-color print cartridge
2 Print cartridge slot for the black print cartridges
4.
Pull the print cartridge toward you out of its slot.
5.
If you are removing the print cartridge because it is low or out of ink, recycle the
print cartridge. The HP Inkjet Supplies Recycling Program is available in many
countries/regions, and lets you recycle used print cartridges free of charge. For
more information, go to the following website:
6.
Remove the new print cartridge from its packaging and, being careful to touch
only the black plastic, gently remove the plastic tape by using the pink pull tab.
Chapter 9
76
HP Officejet 4300 All-in-One series
Maintain the
HP All-in-One