EOTech Target Pointer Illuminator Aiming Light - Manual (Page 32)

2-8
2.3.2 M4/M4A1 Using M4/M16A2 Bracket Assembly. The
AN/PEQ-2A may be mounted to the M4/M4A1 using the
M4/M16A2 Bracket Assembly. However, the top inner heat
shield of the weapon must first be removed and modified as
follows to avoid interference with the bracket mounting
posts:
a. Mark the location of the top inner heat shield that
interferes with the bracket mounting posts and drill
two 3/8” diameter holes.
b. Reinstall the heat shield in the upper handguard and
verify that the holes in the heat shield are aligned
with holes in the handguard.
c. Complete bracket installation and install the
AN/PEQ-2A on the M4/M16A2 mounting bracket per
procedures described in section 2.3.1 for the
M16A2.
Figure 2-5 M4/M4A1 Using M4/M16A2 Mounting Bracket