EOTech Target Pointer Illuminator Aiming Light - Manual (Page 75)

2-51
2.5.1.1 The Safety Block installed in the Training Position
(blue side up) prevents the Mode Selector from being turned
to the high power laser settings (i.e., AIM HI, DUAL LO/HI,
DUAL HI/HI). A .050 hex head wrench is required to remove
the Safety Block and reinstall it in the Tactical Position (black
side up), when access to the high power laser settings is
desired (see paragraph 3.1.7).
Figure 2-30 Safety Block Shown in the Training Position
2.5.2 Mode Activation. Once the mode of operation has
been selected, the AN/PEQ-2A may be used in that mode by
activating the system as follows:
2.5.2.1 Momentary Operation. Pressing and holding the
Fire Button operates the AN/PEQ-2A in the operational
mode set by the Mode Selector. When the button is
released, the AN/PEQ-2A laser(s) shuts off.
Safety Block