EOTech Target Pointer Illuminator Aiming Light - Manual (Page 77)

2-53
2.5.3 Remote Cable Switch. When installed, the Remote
Cable Switch may be used to provide the same functionality
as the Fire Button and is operated in the same manner. The
Remote Cable Switch plugs into the Remote Jack as shown
in Figure 2-32. It is then secured to the weapon to best suit
the operator’s firing preference, using the Retaining Straps
and / or hook and loop fastener tape.
NOTE
The AN/PEQ-2A comes with a Jack Plug installed
in the Remote Jack that must be removed and
stored before installing the Remote Cable Switch.
CAUTION ..
When the Remote Cable Switch is plugged into
the Remote Jack, it automatically locks in place.
To remove it, pull back on the cable plug. Do not
remove the Remote Cable Switch by pulling on the
cable.
Figure 2-32 Installation of the Remote Cable Switch
Cable Plug