EOTech Target Pointer Illuminator Aiming Light User Manual
Page 78
2-54
2.6 USING THE AN/PEQ-2A LASERS
2.6.1 IR Aim Laser. Modes of operation for the IR Aim
Laser are selected and activated as described in paragraphs
2.5.1 and 2.5.2 respectively.
2.6.1.1 Under certain operating conditions, particularly for
boresighting, it may be desirable to reduce the overall power
level of the IR Aim Laser to eliminate blooming effects on the
target. The Neutral Density Lens Cap is provided for this
purpose. To use the Lens Cap, stretch it out and over the
front of the Aim Laser exit port so that it is snug and firmly in
place. See Figures 2-15 and 2-16.
2.6.1.2 For command and control purposes, five Pattern
Generators are also available for the AN/PEQ-2A. When
individually installed over the IR Aim Laser, they project a
specific holographic design over the aim point of the laser.
The shapes are visible when viewed through a night vision
device. The Pattern Generators may only be used one at a
time and may not be used in conjunction with the Neutral
Density Lens Cap. See Figures 2-15 and 2-16.
Figure 2-33 Pattern Generator Shapes