EOTech Target Pointer Illuminator Aiming Light User Manual

Page 57

Advertising
background image

2-33

2.3.15 MK19 Using AN/TVS-5 Mounting Bracket. The
AN/PEQ-2A may be mounted on the MK19 using the
AN/TVS-5 Mounting Bracket and Bracket Adapter.

WARNING

..

Be sure the weapon is CLEAR and SAFE before
proceeding.

NOTE

Failure to fully tighten the Mounting Bracket,
Bracket Adapter or AN/PEQ-2A thumbscrew may
cause zero retention problems.

a. Release the catch at the left side of top cover and

raise the cover to the UP position.

b. Position the AN/TVS-5 Mounting Bracket assembly

over the breech of the Machine Gun and slide it to
the rear until it stops.

c. Swing the three locking cams to the rear to secure

the bracket to the weapon (side cam first, followed
by two top locking cams).

d. Close the cover and secure it with the catch.

e. Attach the AN/PEQ-2A to the Bracket Adapter by

using the thumbscrew.

f. Install the AN/PEQ-2A on the AN/TVS-5 Mounting

Bracket assembly by positioning it in the groove at
the top rear of the bracket so that the scribe line in
the sight on the bracket is aligned with the scribe
line in the sight-mounting adapter. Tighten the lever
screw to secure the sight to the bracket. It will be
easier to tighten the lever screw if you place an

Advertising