EOTech Target Pointer Illuminator Aiming Light - Manual (Page 56)

2-32
b. Position the AN/TVS-5 Mounting Bracket assembly
over the breech of the Machine Gun and slide it to
the rear until it stops beyond the rear edge of the
breech.
c. Swing the three locking cams to the rear to secure
the bracket to the weapon (side cam first, followed
by two top locking cams).
d. Close the top cover and secure with the catch.
e. Secure the Bracket Adapter to the underside of the
AN/PEQ-2A.
f. Place the Bracket Adapter into the M2 bracket
mounting groove with the rear of the adapter flush
with the rear of the bracket. Tighten the bracket’s
lever screw into the Bracket Adapter hole.
Figure 2-18 M60 Using AN/TVS-5 Mounting Bracket and
Bracket Adapter