EOTech Target Pointer Illuminator Aiming Light User Manual

Page 83

Advertising
background image

3-1

CHAPTER 3

MAINTENANCE AND SERVICING

SECTION I

MAINTENANCE AND TROUBLESHOOTING


3.1 MAINTENANCE PROCEDURES
The operator should inspect the AN/PEQ-2A before each
use and after it has been in extreme conditions, such as
prolonged exposure to intense temperatures. The following
procedures will prolong the life of the AN/PEQ-2A and help
ensure safe operation.

3.1.1 Batteries. The battery should be inspected for cracks,
leakage, dents, and bulging. If a battery shows signs of
damage, remove and dispose of properly. Replace battery
as required per paragraph 2.2.2.

3.1.2 Battery Compartments. The Battery Compartments
should be inspected for dirt, dust and corrosion. Dirt or
debris that cannot be shaken loose from the Battery
Compartments may be removed using a clean cloth or
cotton swab.

3.1.3 Battery Cap. The Battery Cap should be inspected for
dirt, sand and grime. Thoroughly clean the Battery Cap by
flushing with water and wiping with a cotton swab.
Periodically lubricate the O-ring with silicone grease. The
Battery Cap should be replaced if the O-ring becomes cut,
nicked, or dried out.

Advertising