EOTech Target Pointer Illuminator Aiming Light - Manual (Page 48)

2-24
NOTE
The AN/PEQ-2A may be placed at any position
(forward and aft) on the rail that is most
convenient for the operator. If, however, the
AN/PEQ-2A is removed from the rail, the operator
must take note of the position at which it was
zeroed, and return it to that same position in order
to ensure that zero is retained.
NOTE
Failure to fully tighten the Rail Grabber Bracket
and AN/PEQ-2A thumbscrew may cause zero
retention problems.
a. Loosen the clamping knob on the Rail Grabber
Bracket until the jaws have sufficient space to fit
over the mounting rail.
b. Position the Rail Grabber Bracket on the rail
ensuring that the recoil lug is seated in the recoil
groove of the rail. Turn the clamping knob clockwise
to tighten. Use a screwdriver or similar tool in the
slot of the clamping knob to fully secure the bracket
to the rail.
c. Mount the AN/PEQ-2A to the Rail Grabber Bracket
as shown in Figure 2-14. Turn the thumbscrew
clockwise to tighten. Use a screwdriver or similar
tool in the slot of the thumbscrew to fully secure the
AN/PEQ-2A to the Rail Grabber Bracket.
d. Install the Remote Cable Switch in a convenient
location (see paragraph 2.5.3).