EOTech Target Pointer Illuminator Aiming Light - Manual (Page 87)

3-5
(3) Separate lanyard from Battery Cap.
(4) Pull large end of replacement lanyard over
battery Cap threads. Position in groove
between O-ring and AN/PEQ-2A housing.
(5) Attach small end of replacement lanyard to the
Battery Cap.
b. Replacement of Lens Caps / Pattern Generators.
No supplies or tools are required to perform this
procedure.
(1) Slide the Lens Cap (or Pattern Generator) to the
side of the AN/PEQ-2A housing to the
uninstalled position.
(2) One at a time, pull both ends of the retaining
strap over the Lens Cap Retaining Pins.
(3) Install a replacement Lens Cap by reversing the
procedure.