EOTech Target Pointer Illuminator Aiming Light - Manual (Page 35)

2-11
2.3.4 M4/M16A4 MWS Using Picatinny Rail Grabber
Bracket. The AN/PEQ-2A may be mounted to the top, right,
or left rails of the MWS using the Picatinny Rail Grabber
Bracket.
WARNING ..
Be sure the weapon is CLEAR and SAFE before
proceeding.
NOTE
The AN/PEQ-2A may be placed at any position
(forward and aft) on the rail that is most
convenient for the operator. If, however, the
AN/PEQ-2A is removed from the rail, the operator
must make note of the position at which it was
zeroed, and return it to that same position in order
to ensure that zero is retained.
NOTE
Failure to fully tighten the Rail Grabber Bracket
and AN/PEQ-2A thumbscrew may cause zero
retention problems.
a. Mount the AN/PEQ-2A to the Rail Grabber Bracket
as shown in Figure 2-7. Turn the thumbscrew
clockwise to tighten. Use a screwdriver or similar
tool in the slot of the thumbscrew to fully secure the
AN/PEQ-2A to the Rail Grabber Bracket.
b. Loosen the clamping knob on the Rail Grabber
Bracket until the jaws have sufficient space to fit
over the MWS rail.