Chatsworth Products Remote Infrastructure Management System Protocol Converter - Manual (Page 12)

RIM-Protocol Converter User Guide - Version 1.0
12 www.chatsworth.com
1.2.1 Rear Panel Indicators
The back of the Protocol Converter has the following indicators:
• Two data transmit/receive indicators to show when data is being transmitted and received through the EIA-485
port (the Dual Port Protocol Converter contains three EIA-485 ports and three sets of data transmit-receive indicators).
When data is either being transmitted or received, the status lights will blink. If no information is being communicated,
the lights are off.
• One status indicator to show when the Protocol Converter is booting up or has an alarm
condition. If neither of these is occurring, the light is off.
Figure 1.1 Protocol Converter Indicators
Table 1.1 LED Indicator Descriptions
Status indicator
Data transmit/receive indicators
(two on the left available with Dual Port Protocol Converter only)
Status Indicator
Status LED
Flashing red: Boot-up Sequence
Solid red: Alarm condition
EIA-485-TX Flashing: Data is being transmitted
EIA-485-RX Flashing: Data is being received