Chatsworth Products Remote Infrastructure Management System Protocol Converter - Manual (Page 25)

RIM-Protocol Converter User Guide - Version 1.0
Chatsworth Products, Inc. (CPI) • 800-834-4969 25
3.3 Configure Network and Web Properties
Use the Configuration section of the Protocol Converter’s web interface to configure basic device functionality. The Network
and Web link displays the MAC address and allows you to fill in the IP Address, Net Mask, Default Router (Default Gateway),
Passwords, and Refresh rate.
In the user interface, go to Configuration>Network and Web. Edit the fields appropriately.
Figure 3.8 Network and Web Configuration Screen
Table 3.1 Network and Web Configuration Fields
Option Description
IP Address
The Protocol Converter is configured at the factory with a default IP
Address of 10.0.0.188. If you’d like to change the IP address, do so here.
Default: 10.0.0.188
Net (Subnet)
Mask
The Protocol Converter is configured at the factory with a default Subnet
Mask of 255.255.255.0. Edit this field as necessary.
Default: 255.255.255.0
Def (Default)
Route The Protocol Converter is configured at the factory with a default Gateway
Route of 10.0.0.1. Edit this field as directed by your IT department.
Default: 10.0.0.1
Web
Password
Read Only
The Protocol Converter can be configured with two passwords - the read
only password allows users to access the web interface but not to edit any
of the configurable settings.
Specify an alphanumeric value up to 16 characters.