Chatsworth Products Remote Infrastructure Management System Protocol Converter - Manual (Page 56)

RIM-Protocol Converter User Guide - Version 1.0
56 www.chatsworth.com
The System webpage displays.
Figure A.1 System Page—Load Flash Firmware
4. Click the Browse button.
5. Locate and choose the firmware file (.bin) that you saved from the CPI website.
6. Click the Upload button.
While the firmware file loads, you’ll see the following confirmation message:
Figure A.2 Firmware Load Messages
When the file is loaded, the Protocol Converter reboots itself. The reboot process takes approximately 60 seconds. After
the reboot, the Home page displays.
7. Click the Identity link on the top bar and verify that the new file has been loaded.
Figure A.3 Identity Link Showing Current Firmware Version