Chatsworth Products Remote Infrastructure Management System Protocol Converter - Manual (Page 43)

RIM-Protocol Converter User Guide - Version 1.0
Chatsworth Products, Inc. (CPI) • 800-834-4969 43
3.6.6 Delete All Registers
If you need to reconfigure the Protocol Converter for a new application, you can delete the entire register set.
IMPORTANT: Consider the Delete All Registers option carefully and use it with caution. You should
use this option only if you need to reconfigure the Protocol Converter for a new application.
To delete all programmed registers:
1. In the user interface, go to Configuration>System.
The System web page displays.
Figure 3.25 System Page—Delete All Registers
2. Click the Delete All Registers button.
A pop-up displays so you can confirm the delete operation.
3. If you are certain you want to delete all programmed registers, click OK. Otherwise, click Cancel.
When you click OK, the registers are immediately deleted.