Samsung SCX-8240NA-CAS - Manual (Page 145)

Printing_ 145
Finishing tab
Use the Finishing tab to set various finishing options.
Click the Finishing tab to display the options shown below.
• Sort Options: This option allows you to sort out the printouts easily.
- None: Disables this option.
- Offset: When printing multiple copies, this option shift the output
position of each set.
This feature is available only when the standard or booklet
finisher is installed.
- Rotate: When printing multiple copies, the printouts are stacked
criss-crossed in sets.
• This feature is available only when the standard or booklet
finisher is not installed.
• This feature is available only with Letter and A4 sized print
media.
• Before using this feature, you have to load the paper in the
trays with SEF(Short edge feed) and LEF(Long edge feed).
For example, direction of paper feeding in the tray 1 is SEF,
and direction of paper feeding in the tray 2 is LEF.
• Staple Options: This option allows you to specify the number of
staples and the staple position. This option is available only when the
optional standard finisher or booklet finisher is installed.
- Staple: Select the number of staples between 1 Staple and 2
Staple.
- Position: Select the position of staples among Left, Right and Top.
When you use the staple and punch together, you can only set
the same position for staples and punch holes.
• Hole Punch Options: This option allows you to specify the number of
hole punches and the hole punching position. Holes are punched in the
printouts for filing them. This option is available only when the optional
punch kit is installed in the optional standard finisher or booklet finisher.
- Hole Punch: Select the number of hole punches between 2 Hole
and 3 Hole. Depending on the punch kit, 4 Hole would appear
instead of 3 Hole.
- Position: Select the position of hole punches among Left, Right
and Top.
When you use the staple and punch together, you can only set
the same position for staples and punch holes
• Output Tray Options: This option allows you to specify the tray where
to output the printed documents.
1 Staple, Left 1 Staple, Right
2 Staple, Left 2 Staple, Right 2 Staple, Top
2 Hole,Left 2 Hole,Right 2 Hole,Top
3 Hole, Left 3 Hole, Right