Samsung SCX-8240NA-CAS - Manual (Page 70)

Copying_ 70
Cover copying
The machine automatically adds covers to your copied set using stock taken
from a different tray. Covers must be the same size and orientation as the
main body of the job.
You cannot use this feature while using Booklet (see "Booklet
copying" on page 68).
1. Press Copy from the display screen.
2. Place the originals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 35).
3. Select the tray, other than Auto, that has the cover paper loaded in the
Basic tab.
• If you select Auto, the Covers feature remains inactive.
• You have to select a tray that has paper of the same size and
orientation as the originals.
4. Adjust the settings for each copy such as Reduce/Enlarge, Duplex and
more in the Basic tab (see "Changing the settings for each copy" on
page 54).
5. Press the Advanced tab > Covers from the display screen.
6. Press the appropriate option.
• Off: Disables this feature.
• Front: Prints the document with the front cover.
• Back: Prints the document with the back cover.
• Front & Back: Prints the document with the front and back cover.
7. Press 1 Sided Printed Sheet in Cover Sheet to select if the cover will
be 1-sided, 2-sided, or blank paper.
8. Select a tray in Paper Source.
9. Press OK from the display screen.
10. Press Start on the control panel to begin copying.
Transparency copying
This feature prevents copies to print onto transparencies from sticking
together as a cause by heat that is produced during copying. You can also
copy originals to the separator sheets.
1. Place the originals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 35).
2. Load the right-sized transparencies with the side to be printed facing
down on the multi-purpose tray.
3. Press Machine Setup > Tray Settings > Settings > MP Tray > Paper
type > Transparency > OK from the display screen.
4. Press ( ) and Copy from the display screen.
5. Press the Advanced tab > Transparency from the display screen.
6. Press the appropriate option.
• No Transparency: Does not place separator sheets between
transparencies.
• Blank Separators: Places a blank sheet between transparencies.
Select a tray which loaded paper for separating from Separator.
• Printed Separator: Places the same image on the separator sheets
as printed on the transparency. Select a tray which loaded paper for
separating from Separator.
7. Press OK from the display screen.
If you did not select Transparency in step 3, a pop-up window
appears.
8. Press Start on the control panel to begin copying.