AltiGen comm 600 - Manual (Page 16)

Alti-IP 600 Manual 6
AltiGen IP Phone Service
AltiGen IP Phone Service is installed together with AltiServ, runs on the
same system as AltiServ, and connects to AltiServ through enhanced
AltiLink+ protocol on behalf of Alti-IP 600 phones. This service must be
running for the Alti-IP 600 to operate. If IP Phone Service stops while the
Alti-IP 600 is on a call, the call will be disconnected.
Plug and Play Feature
The Alti-IP 600 supports a plug and play feature when running AltiWare.
When the phone is first booted up, this feature will enable the phone to
automatically register itself to AltiServ, instead of having to program the
phone manually. Refer to “Configuring Startup Network Settings” on page
12 for requirements and setup.
Note: The Plug and Play feature requires AltiGateKeeper Discovery and
a single gatekeeper on the LAN.
Basic Mode
The Alti-IP 600 operates in Basic mode if it fails to register with AltiWare
during the startup mode. When in basic mode, the IP Phone’s LCD display
shows “
(BASIC) IDLE ”. No AltiWare switching features are available
in this operating mode. However, the phone user can enter a destination IP
address followed by #, and make an outgoing call through the IP network
to reach AltiWare or another Alti-IP 600 phone. Also, the IP phone can
accept incoming calls originating from AltiWare or another Alti-IP 600
phone.
Normal Operation
In normal operating mode, the Alti-IP 600 should have been registered with
the phone server and logged in as an extension. The time and extension
appear in the LCD screen and all phone features are enabled.
Note: To make the Alti-IP 600 work in normal operating mode, open the
firewall port 10032 for the phone server. Refer to the AltiWare OE/
ACC System Installation & Administration Manual or ACM
System Administration Manual for information on other firewall
ports for H.323.