AltiGen comm 600 - Manual (Page 21)

Alti-IP 600 Manual 11
Apply To Button
The Apply To button works with the following parameters: General,
H.323, TFTP (Server field only; Reset IP Phone and Boot Download
options cannot be applied to multiple extensions), Display Workgroup
Status and Debug.
Copy From Button
The Copy From button allows you to copy Function Key settings from
one Alti-IP 600 phone setting to another. No other settings are carried over.
Important: When updating the Alti-IP 600 phone’s firmware, it is
recommended that administrators perform any updates after
normal business hours or when the IP phone is not in use. If the
Alti-IP 600 phone is in use during an update, the call will be
disconnected.
Notes:
• IMPORTANT! Please note that the configuration in AltiWare will
override the Alti-IP 600 phone’s local configuration after the IP
Phone is registered. If the IP phone’s local configuration is changed
while in Basic mode, these changes will be overwritten by
AltiAdmin/ACM Admin settings. Also, after the IP Phone is
successfully registered with the system, the IP phone will overwrite
the AltiWare IP address and network-related settings on the server.
• IMPORTANT! When updating the Alti-IP 600 phone’s firmware,
it is recommended that administrators perform any updates after
normal business hours or when the IP phone is not in use. If the Alti-
IP 600 phone is in use during an update, the call will be
disconnected.
• The Apply To button works with the following parameters:
General, H.323, TFTP (Server field only; Reset IP Phone and
Boot Download options cannot be applied to multiple extensions),
and Debug.
• This only works when the Alti-IP 600 is operating in basic mode.
3. Set Up Alti-IP 600 Connections
You must connect the Alti-IP 600 to the network and to a power source
before using it.