AltiGen comm 600 - Manual (Page 25)

Alti-IP 600 Manual 15
1. Power up the IP phone (the phone should be in basic mode).
2. Press * * 7 + ENTER to go to the IP phone configuration menu.
3. Press * * 2 + ENTER to restore default settings.
4. Reboot the phone (by unplugging the power and replugging OR
pressing $(BACK key) until in Basic mode. The IP phone will
automatically go to normal operating mode after reboot.
5. Enter extension number and password.
6. The time and extension is displayed in the LCD screen after the phone
has been successfully logged on to AltiServ.
7. Set up IP Phone properties in AltiWare as described in Step 2 -
“AltiAdmin/ACM Admin Setup - AltiGen IP Phone Configuration
Window” on page 7.
8. Setup is complete. For further configuration of settings for the Alti-IP
600H/600PH, refer to “Configuring Phone Settings” on page 21.
Remote Installation
To install the Alti-IP 600 at a remote location, using a DSL connection with
or without a router hub:
1. Check the firewall settings at the corporate network to open TCP/UDP
ports required by the Alti-IP 600. (For more information on firewall
settings, refer to “Firewall Considerations” on page 36.)
2. Check the AltiWare server’s IP extension settings (make sure the IP
extension is enabled, enough IP licenses are available, etc.)
3. Press * * 7 ENTER on the Alti-IP 600 phone to configure the phone’s
local IP address and Gateway IP address. (Depending on the DSL
provider’s recommendations, you may or may not want to use DHCP.)
4. Configure the Alti-IP 600 phone’s AltiWare address.