Plug and play setup before ip phone is started, Plug and play setup after ip phone is started – AltiGen comm 600 User Manual
Page 24
Alti-IP 600 Manual
14
•
Gatekeeper auto discovery uses broadcast UDP packets which work in
the LAN or VPN environment, but not through the public IP network.
Plug and Play Setup Before IP Phone is Started
To set up your IP Phone to properly execute the Plug and Play feature,
perform the following steps BEFORE YOU START THE PHONE:
1.
Ensure the AltiGen GateKeeper is running and configured to point to
the AltiWare system.
2.
Ensure DHCP server is up and running.
3.
Ensure that there are enough IP addresses.
4.
Ensure that there is an available virtual extension with the IP extension
feature enabled and dynamic IP address is selected.
5.
Power up the IP Phone.
6.
Enter the extension number and password.
7.
The phone will attempt to register as shown in the LCD screen.
If the phone successfully passes through these stages, the phone shows
the time and extension in the LCD screen and is now in normal
operating mode.
Otherwise, refer to “Troubleshooting” on page 37.
8.
If you wish to change soft keys, you can set up IP Phone properties in
AltiWare as described in Step 2 - “AltiAdmin/ACM Admin Setup -
AltiGen IP Phone Configuration Window” on page 7.
Plug and Play Setup After IP Phone is Started
If you have already started your phone, and wish to execute the Plug and
Play feature, perform the following steps: