AltiGen comm 600 - Manual (Page 23)

Alti-IP 600 Manual 13
If you are not using Gatekeeper Auto Discovery, you must manually
configure the AltiWare IP address setting into the Alti-IP 600. Refer to
“Configuring IP Settings” on page 24.
6. Activate the IP Extension
Once the device is initialized, the user must follow these steps to
activate the IP Extension.
Note: The user must be running AltiGen’s Gatekeeper service for full
functionality.
a. With the handset onhook, press # 27, then the ENTER button.
b. Enter your extension number and password when prompted.
c. The phone will attempt to register as shown in the LCD screen.
If the phone successfully passes through these stages, the phone shows
the time and extension in the LCD screen and is now in normal
operating mode.
Otherwise, refer to “Troubleshooting” on page 37.
Plug and Play Setup
The steps for plug and play setup will vary depending on whether or not the
Alti-IP 600 Phone has been started. When the Alti-IP 600 is started for the
first time, it can support plug and play to enable the phone to automatically
register itself to AltiServ. If the Alti-IP 600 has already been started, follow
the instructions “Plug and Play Setup After IP Phone is Started” on page 14.
Important Notes:
• To use the Plug and Play feature, the user’s IP Phone must be on the
local LAN with AltiServ
• There can only be one (1) AltiServ on the LAN.