AltiGen comm 600 - Manual (Page 22)

Alti-IP 600 Manual 12
Notes:
• When the Alti-IP 600 is booted up without the PC port plugged in,
the PC port defaults to 10Mbps.
• If the PC port is to be used, the user should plug in both the LAN
port and PC port before the IP phone is booted.
• The user should reboot the Alti-IP 600 under any of the following
conditions:
— after disconnecting the LAN cable to the phone
— after changing the IP address or DHCP setting
— after rebooting the PC
Note: If the PC is rebooted during a connected call, the voice
path will be interrupted for 4-5 seconds to reinitialize the
TCP/IP protocol stack.
To connect the Alti-IP 600H/600PH:
a. Connect an Ethernet cable from the IP-PBX to the network port on
the phone.
b. Connect the handset to the receiver jack.
c. Connect an Ethernet cable from another network device, such as a
desktop computer, to the access PC port on the phone.
d. Connect the power plug to the AC Adapter port.
4. Configuring Startup Network Settings
If you are using DHCP, you do not need to configure anything.
Proceed to Step 5.
If you are not using DHCP, you must configure these network settings
on the Alti-IP 600 after installing the phone on the network:
• Local IP address
• IP subnet mask
• Default gateway IP address
5. Configuring the AltiWare IP Settings
If you are using Gatekeeper Auto Discovery, you do not need to
configure anything. Proceed to Step 6.