AltiGen comm 600 - Manual (Page 50)

LCD Messages
40 Alti-IP 600 Manual
AW UNREACHABLE! Failed to connect to the AltiGen phone server. The user
is trying to register the IP phone with an invalid IP
phone’s IP address or the AltiGen Phone Server's IP
address is invalid.
Or, the network connection is lost in offhook or connect
state.
Refer to “ AltiWare is unreachable. ” section
of “The following table provides the most common
problems an end user may encounter. For Alti-IP 600
phone questions or problems not listed here, contact
AltiGen Technical Support.” on page 37.
Basic-Idle! IP phone is operating in Basic Mode.
Execute #27 again to reactivate.
Check IP Phone Service
Verify extension is configured for dynamic.
DHCP FAIL! Although DHCP was enabled, the Alti-IP 600 was not
able to receive the IP address from the DHCP server.
INVALID IP!
INPUT AGAIN...
The inputted IP address is invalid.
INVALID VAL! During register of IP extension, an invalid response
(return value) returned from phone server.
NO IP ADDR! Alti-IP 600 cannot attach an IP address due to network
failure.
No Network! Phone has lost Ethernet connection.
REGISTER FAIL! Cannot register to the AltiGen phone server.
REGISTER OKAY! IP extension registered successfully.
REGISTERING! User entered #27 to manually register the IP extension.
REMOVE OLD EXT. When #27 is entered, the extension/password
configuration in the IP Phone is removed.
WRONG PASSWORD! Registration failed because of invalid extension
password.