Anritsu S251B - Manual (Page 59)

Setting the Markers
The following procedure sets the markers.
Step 32. Press the MARKER key to call up the Markers menu.
Step 33. Press the M1 soft key to select the M1 marker function. Press the EDIT soft key
and enter 8, 2, 4 using the keypad or Up/Down arrow key. Press ENTER to set
M1 to 824 MHz. (Note: pressing the ON/OFF soft key activates or deactivates
the M1 marker function.)
Step 34. Press the BACK soft key to return to the Markers menu.
Step 35. Repeat steps 33 and 34 for markers M2, M3, and M4. Set M2 to 960 MHz, M3
to 1710 MHz, and M4 to 1990 MHz. Figures 4-10 and 4-11 depict the SWR and
Return Loss measurements).
NOTE:
Refer to page 4-4 for instructions on saving and recalling a setup or display.
4-13
Chapter 4 Measurements
Figure 4-10. Cable SWR Measurement Results
Figure 4-11. Cable Return Loss Measurement Results