Anritsu S251B - Manual (Page 77)

Capture multiple traces to a database
Step 1. Connect the supplied cable as shown in Figure 5-2.
Step 2. Open the Site Master Software Tools program.
Step 3. Double-click on the “Site Master Software Tools” icon to open the program.
Step 4. Click on Capture , in the top menu bar, and select Capture Plots To Database
from the drop-down menu.
Step 5. Follow the database instructions to download the plot(s) to either a new database
or an existing database.
Step 6. Enter the number(s) of the stored-display memory location(s) (1 to 200) from
which you wish to store to the database, and click OK .
Step 7. Observe that the “Acquiring Control” box appears on the screen, then disappears
as traces are automatically acquired. The “Database” box appears when the
plot(s) has been completely captured into the database.
Capture single or multiple traces to PC screen
Step 1. Perform steps 1, 2, and 3 of the capture-multiple-traces-to-database procedure.
Step 2. Click on the Start Plot Capture icon or click on Capture , in the top menu bar,
and select Capture Plots to Screen from the drop-down menu.
Step 3. Enter the number (or numbers) of the stored-display memory location(s) (1 to
200) from which you wish to display traces in Site Master Software Tools.
Step 4. Select OK .
Step 5. Observe that the “Acquiring Control” box appears on the screen, then disappears
as the traces are automatically acquired and displayed.
5-4
Chapter 5 Software Tools Program
COM port
(Program defaults to COM2)
Serial Interface
HOLD RUN
START
CAL AUTO
SCALE
SAVE
SETUP RECALL
SETUP
LIMIT MARKER
SAVE
DISPLAY RECALL
DISPLAY
PRINT
MODE FREQ/DIST AMPLITUDE SWEEP
SYS
ENTER
CLEAR
ESCAPE
ON OFF
/
1 2
4
5 6
7 8
9 0
3
+ -
.
Site Master S251B
625.0 2500.0
1384.45 MHz 2096.66 MHz
Figure 5-2. Serial Cable Connection