Dtf mea sure ment 4-16, Re quired equip ment 4-16, De vice-un der-test spec i fi ca tion 4-16 – Anritsu S251B User Manual
Page 62: Pro ce dure 4-16, Se lecting the mea sure ment mode 4-16, Dtf measurement -16, Required equipment -16, Device-under-test specification -16, Procedure -16, Selecting the measurement mode -16
DTF Measurement
The following distance domain measurement is an example of a Distance-to-Fault (DTF)
measurement over a selectable distance range.
Required Equipment
·
Site Master Model S251B
·
Precision Open/Short, Anritsu 22N50 and
Precision Load, Anritsu SM/PL
or
Precision Open/Short/Load, Anritsu OSLN50LF
·
Test Port Extension Cable, Anritsu 15NNF50-1.5A
Device-Under-Test Specification
Procedure
Step 1. Press the
ON/OFF
key on the Site Master.
Selecting the Measurement Mode
Step 2. Press the
MODE
key.
Step 3. Use the Up/Down arrow key to scroll to
DTF-SWR
or
DTF-RETURN LOSS
.
Step 4. Press the
ENTER
key to select DTF-SWR or Return Loss measurement mode. If
the Site Master has not been calibrated (CAL OFF displayed in the upper left of
the display), the DTF AID parameter table will appear.
NOTE: Where CAL ON is indicated on the Site Master, pressing the DTF AID
soft key will activate the DTF parameter table. However, distance and cable
type (propagation velocity and loss) have not been optimized. F1 and F2 are
set by “CAL ON” setup. DTF measurement is valid for D2
£
D
max
(as defined by
F2 and F1).
The number of data points (resolution) will automatically adjust according to the
length of D2.
Step 5. Use the Up/Down arrow key to scroll to
D2
, then press
ENTER
to select the ca-
ble length.
Step 6. Enter 2 using the keypad or the Up/Down arrow key. Press
ENTER
to set D2 to
2.0 meters.
4-16
Chapter 4 Measurements
Type
Typical Loss @1.5m
V
g
Return
Loss
SWR
15NNF50-1.
5A
0.4 dB @ 625 MHz
0.5 dB @ 800 MHz
0.6 dB @ 1000 MHz
0.7 dB @ 1500 MHz
0.8 dB @ 2000 MHz
0.9 dB @ 2500 MHz
0.86
³
21 dB
£
1.20