Baldor GLC GENERATOR GLC45 - Manual (Page 36)

3-4 Receiving & Installation MN2408
Hot Exhaust Gasses
WARNING: Exhaust fumes/gases are extremely dangerous and can cause severe illness or death. Never
breath exhaust fumes produced by a running engine. Only run the engine outdoors where
ventilation is plentiful. Exhaust gases contain carbon monoxide, a colorless, odorless and
extremely dangerous gas that can cause unconsciousness or death. Symptoms of carbon
monoxide poisoning include: dizziness, nausea, headaches, sleepiness, vomiting or
incoherence. If you or anyone else experiences these symptoms, get out into fresh air
immediately. Stop the engine and do not restart the engine until it has been inspected and if
necessary repaired or reinstalled in a well ventilated area.
WARNING: Hot exhaust gasses must never be directed toward anything that may catch fire or explode.
It is extremely important to discharge engine exhaust gasses away from the engine and out of
the building. If these gasses remain in the cylinder, poor performance or eventual engine damage
may result. This condition results from excessive back–pressure, which could be caused by any
one or a combination of the following conditions:
1. Exhaust pipe too long or the diameter is too small.
2. Excessive number of sharp bends in the exhaust system.
3. Obstruction in the exhaust system.
Backpressure must not exceed 20” of water column.
The direction of the discharged hot air and hot exhaust gases is important as they have the
potential to create brown spots on the lawn. In extreme cases this extremely hot air could cause
dried grass or other debris to ignite.
Exhaust lines should be as short and straight as possible. Long pipe lengths and elbows tend to
resist the flow of gases and accumulate carbon deposits. Each pipe fitting and elbow will further
restrict the exhaust flow.
Guidelines for Exhaust System
1. If you are using a remote muffler it should be mounted as close to the engine as
possible, since it will clog with carbon if it’s operating temperature is too low.
2. If you are using a remote muffler a flexible coupling of 12” or more must be installed
between the exhaust line and the manifold to absorb the engine’s vibration. However,
a short, solid section of pipe between 6” and 8” long should be placed between the
connection of the manifold and the flexible coupling. This nipple will reduce the
possibility of the hot gases burning up the flexible coupling.
3. It is extremely important that you do not allow the hot exhaust gases to re–circulate into
the engine’s cooling air intake.
4. Water is one by–product of combustion and is present in the exhaust pipes or muffler.
This water must be kept from draining back into the engine. This can be done by
slanting the horizontal section of the exhaust system piping downward slightly, away
from the engine. A water trap consisting of a tee extension with a drain cock should
also be provided. This water trap should be located between the flex coupling and the
muffler, but as close to the engine as possible on a horizontal section of the exhaust
piping.
5. It is also recommended that an exhaust rain cap be used whenever it is possible that
rain could get into the system. This will help to prevent corrosion and damage to the
exhaust system and engine.
6. The exhaust system is subject to the engine’s vibration and it must therefore be solidly
secured to reduce mechanical stress and the potential for breakage.
7. The engine’s exhaust system is the hottest component of the installation and extreme
care and considerations must be given to it.