Pioneer MEP-7000 - Manual (Page 15)

CONNECTIONS
15
En
English
CONNECTIONS
Whenever connecting or disconnecting components, be sure to first turn off the power and disconnect the power cord from its outlet first.
Damage to the unit may result if connections are modified while power is supplied.
NORMAL STYLE CONNECTIONS
1. System connections
Use the provided dedicated remote control cable to connect the control unit to the drive unit. Insert firmly until you hear a click.
2. Connections to DJ mixer (DJM-3000/DJM-800) (audio output and control connections)
Using the accessory audio cable, connect the white plug to the L (left) channel connector and the red plug to the R (right) channel
connector. By connecting the accessory control cord, this unit can be controlled from a Pioneer DJ-mixer so as to allow fader start
play and back cue operations (except during relay play).
MEMO
• When connecting to the DJM-300, DJM-500 or DJM-600, use the accessory audio cable to connect the CD1 to the drive unit’s
side A output connectors, and CD2 to the drive unit’s side B output connectors as shown in the accompanying illustration.
PC
MONITOR OUT REMOTE CONTROL
5V
AC IN
A B
DIGITAL OUT REMOTE CONTROL
A B
AUDIO OUT AUDIO OUT L
R
CONTROL CONTROL
L
R
USB1 PC
REMOTE
CONTROL
Control unit
Drive unit
Accessory
dedicated
remote control
cable
Accessory audio cable
Accessory audio cable
Drive unit
Accessory
control cord
Accessory
control cord
DJM-3000
MEP-7000_WY_EN.book 15 ページ ２００９年２月１２日 木曜日 午後８時２１分