Pioneer MEP-7000 - Manual (Page 25)

HANDLING DISCS AND OTHER MEDIA
25
En
English
 To disconnect a USB storage device
1
Hold the STOP button pressed for two second or more.
2 Confirm that the indicator goes out.
Confirm on the front panel that the red indicator for the
connected port has change from flashing to off.
3 Disconnect the USB storage device.
CAUTION
Depending on the device used, proper playback may
not be possible with all USB storage devices. Pioneer
assumes no responsibility for any loss of data
resulting from connecting any given USB device to
this unit.
• Proper operation may not be possible when a USB storage
device is connected through a USB hub.
• Even if a USB hub is used to connect multiple USB storage
devices, the second and later devices cannot be used.
• Operation cannot be guaranteed when using a USB
storage device with installed flash card reader.
• When connecting a USB storage device utilizing two USB
cables, connect both cables to this unit’s USB ports.
• If an electrical current stronger than the allowable current
is applied to the unit’s USB1 port or USB2 port, the unit may
stop supplying power to the USB storage device, thus
terminating transmission. In this case, a message will be
displayed in the center display of the unit, and the stop
indicators for USB1 and USB2 will flash red
simultaneously. To restore normal operation, disconnect all
USB storage devices connected to the unit, then hold either
of the USB STOP buttons depressed for two seconds or
more. Avoid connecting the USB storage device from which
the excess current was detected and other USB storage
devices connected through a bus-powered USB hub. If
normal operation is not restored through this method, turn
the power of this unit off, and then turn it back on.
MEMO
• After the indicator goes out, if the STOP button is held
depressed for two seconds or more, the USB storage device's
connection can be reinitiated without the need to physically
disconnect and reconnect it.
CAUTION
When disconnecting a USB storage device, always be
sure to perform the STOP operation first.
If the STOP operation is not completed before
disconnection, cue/loop memory and playlist update
may not occur properly, resulting in the loss of data.
Also, the USB storage device may becomes
unreadable, or other substantial damage may occur.
In the case of a HDD device, do not subject it to
impact or vibration during use.
Always disconnect the USB storage device before
turning off the power to this unit.
MEP-7000_WY_EN.book 25 ページ ２００９年２月１２日 木曜日 午後８時２１分