Pioneer MEP-7000 - Manual (Page 33)

START PLAYBACK (Using normal connections)
33
En
English
 Changing the playlist’s track order
1
Select the track you wish to move from the playlist.
2 Press the rotary selector dial.
• A menu will appear in the right window.
3 Turn the rotary selector dial to select [MOVE TRACK], then
press the rotary selector dial.
• A yellow line will be displayed.
4 Turn the rotary selector dial to the place you wish to move
the track.
5 Press the rotary selector dial.
• The track selected in step 1 will be moved to before the track
selected in step 4, and the display will return to the playlist.
 To delete tracks from a playlist
1
Select the track you wish to delete from the playlist.
2 Press the rotary selector dial.
• A menu will appear in the right window.
3 Turn the rotary selector dial to select [DELETE TRACK], then
press the rotary selector dial.
• The track will be deleted from the playlist.
• A track cannot be deleted when it is set in the controller.
 To close a playlist
1
When a playlist is open, press the select up ( ) button.
 To delete a playlist
All tracks recorded in the playlist will be deleted from the playlist.
1
Select the name of the playlist.
2 Hold the rotary selector dial depressed for one second or
more.
The [CANCEL], [RENAME], [ALL TRACK CLEAR] menu will
appear.
3 Turn the rotary selector dial and select [ALL TRACK CLEAR].
4 Press the rotary selector dial.
All tracks recorded in the playlist will be deleted from the
playlist (the playlist will be empty).
• A track set in the controller cannot be deleted from the
playlist.
 Saving a playlist
Whenever tracks are recorded, erased, or edited in a playlist, the
new playlist is automatically saved (saving occurs about five
seconds after an editing operation is performed, assuming no
further command input).
 Editing the name of a playlist
1
Select the desired playlist
2 Hold the rotary selector dial depressed for one second or
more.
• A menu will appear on the right side of the center display.
3 Use the rotary selector dial to select [RENAME], then press
the rotary selector dial.
4 Enters edit mode. Use the rotary selector dial to edit the
name of the playlist.
• A maximum of 32 characters can be input.
Select up (
) button:
Delete previous character to cursor.
Select down ( ) button:
Inputs same character as last input, and moves to next input
position.
Press rotary selector dial:
Save edited contents and leave editing mode.
Rotate rotary selector dial:
Select character type: Upper case  lower case 
numerals  symbols
5 When editing is completed, press the rotary selector dial.
• The playlist will flash, indicating that editing is completed.
NOTE
• If the unit’s power is turned off immediate (within five
seconds) after editing a playlist, the results of the edit may
not be reflected properly.
MEMO
• Two-byte characters are not supported.
• For information on using a keyboard for editing, see the section
“TRACK SELECTION WITH A USB KEYBOARD” (P. 30).
MEP-7000_WY_EN.book 33 ページ ２００９年２月１２日 木曜日 午後８時２１分