Pioneer AVIC-X3-II - Manual (Page 136)

System detected that the ver-
tical angle of the installation
exceeds the permission level.
Please install the navigation
unit correctly.
The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle. Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details refer to
Installation Manual.)
Route calculation was not
possible. Route calculation has failed be-
cause of a malfunction of map data,
software, hardware or disc.
• Change the destination.
• Clean the disc.
• Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation was not
possible because the destina-
tion is too far. The destination is too far.
• Set a destination closer to the starting
point.
• Set one or more way points.
Route calculation was not
possible because the destina-
tion is too near. The destination or way point(s) are
too close. Set a destination or way point(s) farther from
the starting point.
Route calculation was not
possible due to traffic regula-
tions. • The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the route
calculation is hampered. • Set a destination and way point(s) outside
the CTR if you know where the restricted area
is.
• Try a destination or way point(s) away from
the currently set points to some extent.
• Drive your vehicle to an unrestricted area
and reset the destination and way point(s).
Route calculation was not
possible because no guidance
can be provided around the
destination or the starting
point. The destination, way point(s) or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible. • Set a destination and way point(s) on roads.
• Reset the destination after you drive the ve-
hicle to any road.
There is no route to the desti-
nation. The destination or way point(s) are
on an isolated island, etc. without a
ferry and the route calculation is im-
possible. Change the destination.
Your journey can not avoid
the specified area If route setting cannot avoid speci-
fied
Areas to Avoid.
If the current route is not desired, set a desti-
nation or way point(s) that do not pass
through
Areas to Avoid.
The route could not avoid the
specified area. Toll road has
not been avoided. If the route to the destination or way
point(s) cannot be established by
bypassing toll roads (including toll
areas) and
Areas to Avoid.
If the current route is not desired, set a desti-
nation or way point(s) that do not pass
through toll roads (including toll areas) and
Areas to Avoid.
Ferry has not been avoided. In case a ferry route was included in
the route to the destination or way
point(s) even though [
Avoid Ferry]
was set to [ On].
If the current route is not desired, set a desti-
nation or way point(s) that do not pass
through a ferry route.
Toll road has not been
avoided. If the route to the destination or way
point(s) cannot be established by
bypassing toll roads (including toll
areas). If the current route is not desired, set a desti-
nation or way point(s) that do not pass
through toll roads (including toll areas).
There is no applicable data for
the selected city. Automati-
cally returning to list. If the history data of the city could
not be used (for example, if the his-
tory data of the city that was used in
POI Search cannot be found in Ad-
dress Search). Once the search is performed to specify the
city, the result is saved as a history. The data
of the specified city, however, may not be hit
by the different search criteria. In this case,
try another search method or change the des-
tination.
Appendix
Engb
136
Appendix