Pioneer AVIC-X3-II - Manual (Page 145)

• Hardware Info s*
• Restore Factory Settings
1
*: Product Number in Service Info Screen is not dis-
played.
Shortcut menu
: Destination —
: Change Route s
: Registration 1
: Vicinity Search —
: Volume Setting
—
: Whole Route Overview 1
: Overlay POI —
: Address Book
—
: Route Options s
: Edit Current Route —
: Traffic On Route
—
About the icon for the memory
navi mode
When new route guidance starts, the route
data from the DVD Map Disc is read into the
memory of the navigation system. The status
of the memory navi mode is indicated by the
following icons on the lower right of the map
screen.
(Green flashes): Reading the data
(Green is lit): Operated in memory navi
mode
(Red flashes): Operated in memory navi
mode, but the remaining distance for gui-
dance is less than 20 km.
p Where the navigation guidance is impossi-
ble, the icon is lit in red. In that case, rein-
sert the DVD Map Disc.
When disappears, memory navi mode is
ready. You can now remove the DVD Map
Disc.
p If you want to remove the DVD Map Disc
while preparing for the memory navi mode,
press EJECT button more than 2 seconds.
When the DVD Map Disc is removed, data
cannot be read any more and preparation
for memory navi mode will be cancelled ac-
cordingly. (Since the reading of the map
data used in the memory navi mode is not
complete, the map scale may switch to a
larger scale. In this case, route guidance
will continue up to the location already
memorised.)
In memory navi mode, you will be notified in
three cases: when the distance to the edge of
the memorised area is 20 km (12 miles), 10 km
(6 miles) and 5 km (3 miles) respectively.
Preparation for memory navi mode will have to
be repeated if the vehicle enters an unrec-
orded area, then returns to an area stored in
the disc. (Preparation for the memory navi
mode starts from the location where the vehi-
cle re-entered the area stored on the disc.)
Major restrictions during the
memory navi mode
! The scale cannot be zoomed freely.
! If a route was set to your destination in
memory navi mode, inserting the DVD Map
Disc automatically starts recalculation of
another route. (You cannot cancel this re-
route operation. If the route calculation
fails for some reason, a message will ap-
pear asking you to either recalculate a
route (
Reroute) or delete the current route
(Delete route). In this case, drive for a while
before touching either
“Reroute” or “De-
lete route
” to delete the current route, then
reset the destination.)
! In some cases, you may not be able to use
map display mode during DVD navi mode.
If the map display mode is not changed
during memory navi mode, the display will
return to the map display mode used dur-
ing the DVD navi mode when the DVD Map
Disc is set again.
Appendix
Engb
145
Appendix
Appendix