Pioneer AVIC-X3-II - Manual (Page 24)

To Protect the LCD Panel
and Screen
p Do not allow direct sunlight to fall on the
LCD screen when this product is not being
used. Extended exposure to direct sunlight
can result in LCD screen malfunction due
to the resulting high temperatures.
p When using a mobile phone, keep the aer-
ial of the mobile phone away from the LCD
screen to prevent disruption of the video
with disturbances such as spots or co-
loured stripes.
p To protect the LCD screen from damage, be
sure to touch the touch panel keys with a
finger. (The stylus is supplied for special ca-
librations. Do not use the stylus for normal
operations.)
p Using force to manually adjust the LCD
panel angle may damage the LCD panel.
For Viewing LCD Comfortably
Due to its construction, the viewing angle of
the LCD screen is limited. The viewing angle
(vertical and horizontal) can be increased,
however, by using
Brightness to adjust the
black density of the video. When using for the
first time, adjust the black density in accor-
dance with the viewing angle (vertical and hor-
izontal) to adjust for clear viewing.
Dimmer
can also be used to adjust the brightness of
the LCD screen itself to suit your personal pre-
ference.
Resetting the Microprocessor
CAUTION
Pressing RESET button deletes the contents of
the system
’s memory.
About the data being deleted
The information is erased by pressing RESET
button or disconnecting the yellow lead from
the battery (or removing the battery itself).
However, the following items are not erased:
! Sensor learning status and driving status
! Memory areas that were memorised manu-
ally
! Areas to Avoid
! Registered Locations in “Address Book”
Reset the navigation system
without changing the
condition memory
Pressing RESET button of the navigation sys-
tem lets you reset the microprocessor to its in-
itial settings without changing the condition
memory.
The microprocessor must be reset under the
following conditions:
! Prior to using this product for the first time
after installation.
! If the product fails to operate properly.
! If there appear to be problems with the op-
eration of the system.
! When changing the combination of the
equipment.
! When adding/removing additional pro-
ducts that connect to the navigation sys-
tem.
1 Turn the ignition switch OFF.
2 Press RESET button with a pen tip or
other pointed instrument.
RESET button
p If you have connected other equipment (for
example, Bluetooth adapter) to this naviga-
tion system, be sure to reset that equipment
too.
Introduction
Engb
24
Chapter
01